A lot of population will not use the range hoods that they have because they are old and they make too much noise. Unfortunately if you do not use your hood when cooking this can consequent in the odors, smoke and steam to spread throughout your home and then cause you problems in the future. However a range hood facility is quite a easy procedure and is something that you yourself should be able to perfect in a morning.
In order to carry out the work there are a number of different tools and materials that you will need.
Akdy Hood
1. Range Hood
2. Screwdriver
3. Pencil
4. Circuit Tester
5. Wire Nuts
6. Screws (these should commonly be in case,granted with the new range hood that you have purchased).
The first thing that you should when preparing to remove an old hood and replacing with a new one is switched of the power contribute to that particular area of the kitchen. Once this has done you can then carry out the following steps. However in order to replace it you will need man to help you. Also ensure that you have the right size hood remember that the new one should overlap the cooker top on each side by about 3 inches.
Step 1
Firstly you will need to find the electrical association for this particular appliance. Often it is located in a position close to the light fitting on the hood. Once you have located the wiring you need to disconnect it by removing the wire nuts. As soon as the nuts are removed you will need to detach the connections.
Step 2
Now you have disconnected the wiring you now need to ask man to reserve the weight of the hood whilst you loosen the screws which hold it in place. remove the hood off of the screws which are supporting it and then put it to one side. Then you can finally remove the screws completely.
Step 3
You now need to part how far down the old hood was placed. Hopefully if it was colse to about 24 to 30 inches from the top of the stove top then this is okay. But if not then you will need to carry out some alterations to ensure that the base of the hood from the top of the stove falls within this range. Also ensure that you have adequate wiring also.
Step 4
It is foremost that you look at the direction in which the venting is going. This should either run up through the cabinet or out through the wall at the back. With most range hood facility projects you will find that contemporary hoods are able to accommodate both kinds of venting quite easily. However it will genuinely depend on just what kind of holes it has in order for it to gain access to the ductwork.
Once you have supplanted the old hood with the new one by carrying out the above steps starting at number 4 and going back up to step 1. Then you will need to tighten up the screws which are used to reserve it and ensure that they are wholly secure. The final things you will need to do once you have completed your range hood facility is to test the electrics by turning on the fan and the lights to see if they are working correctly.
easy Instructions For A Range Hood installationRelated : Motorcycle Store video games Store